BYK CAP 1000+, Руководство пользователя, Страница: 10 / 32

10
Installation
I.4 INSTALLATION
NOTE: DO NOT lift the viscometer by the handle or display panel!
LIFT by the base console or column!
1) Set the viscometer on a clean level bench surface.
2) Remove shipping spindle blank and foam packing from CAP Viscometer. Store
the spindle blank in the spindle case. Use again only when transporting CAP
Viscometer.
3) Verify that the viscometer’s power requirements match your power source
BEFORE connecting it to power.
The AC input voltage and frequency must be within the appropriate range
as shown on the name plate of the viscometer.
NOTE: The CAP Viscometer must be earth grounded.
Use the three (3) wire power cord! Do not alter!
4) Connect the power cord to the viscometer and to the power supply (source).
5) If using a printer, connect the printer cable to the printer port and printer.
NOTE: Ensure that both the printer and the CAP-1000+ are off when connecting
cables.
Foam Insert Used
When Shipping
CAP Viscometer
Figure I-2: Detail of Foam Insert