![background image](http://html.mh-extra.com/html/bushranger/csg010/csg010_owners-manual_2835567022.webp)
Problem
Cause
Water is Not Hot Enough
Adjust the gas regulator and water
regulator to meet your desired temper-
ature. To Increase temperature; turn the
gas regulator control from minimum to
maximum and turn the water regulator
control from maximum to minimum.
Also, switch burners from “Low” to
“High”.
Check source water temperature. If the
source water temperature is too cold
then you may need to recirculate the
water through the system back into
the source reservoir then through the
appliance again to meet your desired
temperature.
Check if there is a blue flame in the
‘viewing window’. If you see a yellow
flame there may be debris in the unit.
Turn unit off immediately. Try to clear
debris with compressed air. If further
assistance is required please call 1800
654 767.
Check your Gas Cylinder to ensure it is
not empty. If using a new cylinder; try to
cycle the unit on and off by using the
Shower Head switch several times to
purge the air from the gas lines.
Water Pump not working
Make sure the power source for the
pump is adequate enough and has
enough charge to operate the pump
Ensure all connections are securely
joined and the switch is in the ON
position
Pressure switch may be broken.
Pump motor may have failed.
Troubleshooting
(continued)
Technical Assistance and Spare Parts
The Bushranger Gas Hot Water Shower has been inspected, tested and set by expert personnel prior to
leaving the factory to guarantee quality.
We always recommend contacting the place of purchase, specifying the model, serial number and type
of problem you are having with the unit. If unavailable contact:
Kingsley Enterprises Pty Ltd
PO Box 6007, Minto BC 2566
Phone:
Fax:
1800 654 767
1800 655 196
International:
Email:
+612 8700 0400
| Gas Hot Water Shower
Page 19
Содержание CSG010
Страница 1: ...CSG010 ...