Safety Features
This appliance has been designed in accordance with and tested to AS2658. It is
equipped with the following safety features:
Over-temperature sensor
– the appliance will not allow the burner to remain in
operation once the outlet water temperature reaches 50°C. To relight the burner
you will need to either:-
- Turn the switch off on the unit and allow cool water to flow through the unit until it
drops the internal temperature low enough to reignite the burner.
- Turn the water flow and gas off, allow unit to cool for 30min then reignite.
Water flow sensor
– water must be flowing through the system to allow the burner
to ignite. In the case that the water supply is restricted or no longer flows. For
example, if you close the water flow at the shower nozzle, the burner will be
extinguished and will not relight until the water flow recommences.
Tilt Switch
– this safety device will not allow the burner to operate if the appliance
is any more than 45 degrees from its normal operating position. To relight the
burner you will need to turn the water flow off, position the appliance to the
normal operating position and turn the water flow back on.
Exhaust Flue Sensor
– the appliance will shut down if the exhaust flue becomes
partially or fully restricted from operating properly. To relight the burner, turn all
gas and water devices off, remove restriction or re position the appliance in safe
operating location and start the appliance as per instructions.
List of Parts Supplied
•
1 x LPG Portable Water Heater
•
1 x Gas hose and Regulator assembly
•
2 x Batteries ‘D’ Cell
•
1 x Water Pump – 4.3L/min, 12V DC
•
1 x Shower Rose with Hose and On/Off Switch
•
2 x Hose + hose fittings
•
1 x Pump wiring harness
Not included: Spanner, Screw Driver, Fresh Water Tank/Container or similar, Water
Pump 12V DC Power Supply and Gas Bottle.
If required, contact Bushranger 4x4 Gear for advice on the above items.
| Gas Hot Water Shower
Page 6
Содержание CSG010
Страница 1: ...CSG010 ...
