Bushnell 119773C Aggressor, Инструкция по эксплуатации

Страница: 34 / 40

34
b
. Make sure that the camera has good batteries in it. Near the end of the
battery life, the camera may choose to record shorter video clips to conserve
power.
c
. When LED Control is set to "High" and camera is in Video mode, the
maximum available video length is 15 seconds to avoid potential overheating of
batteries and/or electronic components.
Date/Time Stamp not appearing on images
Make sure that the “Time Stamp” parameter is set to “On”.
Photos Do Not Capture Subject of Interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting.
For warm
temperature conditions, set the Sensor Level to “High” and for cold weather
use, set the sensor for “Low”. For variable weather, use "Auto".
2. Try to set your camera up in an area where there is not a heat source in the
camera’s line of sight.
3. In some cases, setting the camera near water will make the camera take images
with no subject in them. Try aiming the camera over ground.
4. Try to avoid setting the camera up on small trees that are prone to being moved
by strong winds.
5. Remove any limbs which are right in front of the camera lens.
PIR Sensor LED Flashes/Doesn’t Flash
1. When the camera is in the “Setup” mode, a special LED on the front of the
camera will flash when it senses motion. This is for setup purposes only and will
help the user aim the camera.
2. During use, the LED will not flash when the camera takes an image. This is to
help keep the camera hidden from game.
LCD Screen Issues
1. LCD screen powers on but no text is present.
a
. After moving the switch from “Off” to “Setup” or “On”, make sure t h a t
the switch is correctly in position to ensure the proper mode (avoid positions
“between” two modes).
b
. Do not move the switch directly from “On” to “Setup”-always move the
switch all the way down to “Off” first, then back up to “Setup”.