Bushnell 119773C Aggressor, Инструкция по эксплуатации

Страница: 11 / 40

11
to its current parameter settings) when it is triggered by the PIR sensor’s detection of
activity in the area it covers.
You can either move the power switch directly from OFF to ON mode, or stop at the
SETUP position first to change one or more settings, then move the switch to ON
after you have finished doing so.
SETUP MODE
In the SETUP mode you can check and change the settings of the Trophy Cam
HD Aggressor with the help of its built-in LCD. These settings, found in the SETUP
Menu, let you change the photo or video resolution, interval between photos, switch
the time imprint on, etc. Moving the power switch to the SETUP position will turn on
the LCD display, and you will see an information screen that shows how many images
have been taken, the battery level, camera or video mode, etc (
Fig. 3 , next page
).
NOTE: Always move the power switch from
OFF
to
SETUP
mode. It is possible
that the camera could lockup if it is switched from ON to SETUP mode. If this
occurs, simply move the switch to
OFF
and then push it up to
SETUP
again.
SETUP Mode Shortcut Keys/Functions
As mentioned earlier in “Parts & Controls”, four of the keys below the LCD
have secondary, “shortcut” functions when the camera is switched to SETUP mode
(but the MENU key has not been pressed):
• Press the UP key to quickly set the camera to shoot video clips.
• Press the DOWN key to quickly set the camera to take still photos.
• Press the RIGHT key to manually trigger the shutter. This is useful for testing the
camera-make sure you are in SETUP mode, press the RIGHT key, and a few
seconds later a photo or video (depending on how the camera was set) will be
saved to the SD card (or internal memory if no card is inserted). The “number of
images taken” counter on the bottom left of the LCD will increase by one. If the
display indicates “SD PROTECTED” when you press the SHOT key, switch the
camera OFF, remove the SD card and slide its protect switch off.