Burstner I 690 G, Инструкция по эксплуатации

Страница: 211 / 304

211
I-Modell - 13/14 - Ausgabe 08/13 - 2354644 - BUE-0056-07EN
Sanitary fittings
10
„
Position the vehicle horizontally.
„
Switch on 12 V power supply on the panel.
„
If necessary, switch on the water pump on the panel.
„
Clean or disinfect water system.
„
Close the safety/drainage valve (Truma). Turn the knob perpendicular to
the safety/drainage valve and press the push button in.
If the temperature is below 6 °C, the safety/drainage valve cannot be
closed. Therefore switch on the living area heater and wait until the tem-
perature of the safety/drainage valve exceeds 6 °C.
„
Close all drain cocks. To do this, position the drain cock's rocking lever
(Fig. 235,1) horizontally or turn the drain cock's cap (Fig. 236,1) in a clock-
wise direction.
„
Close the drainage opening of the water tank.
„
Close all water taps.
„
Open the drinking water filler neck on the outside of the vehicle.
„
Fill the water tank with drinking water. Use a water hose, a water canister
with a funnel or similar for filling.
„
Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
„
Keep the taps open until the water flowing out of the taps has no bubbles
in it. This is the only way to ensure that the boiler is full of water.
„
Set all water taps to "Cold" and leave them open. This will fill the cold water
pipes with water.
„
Keep the taps open until the water flowing out of the taps has no bubbles
in it.
„
Close all water taps.
„
Close drinking water filler neck.
„
Check that the cap on the water tank is not leaking.
Position of the drain
cocks and safety/
drainage valve
See chapter 16.
Fig. 235 Drain cock (with rocking lever) Fig. 236 Drain cock (with twist cap)