Burstner I 690 G, Инструкция по эксплуатации

Страница: 200 / 304

200
I-Modell - 13/14 - Ausgabe 08/13 - 2354644 - BUE-0056-07EN
Appliances
9
When changing over from 230 V or 12 V to gas, delay times are built into the
AES. For example, when changing over from 12 V operation to gas operation,
a 15 minute delay is built in the AES. This prevents a change-over to gas oper-
ation when the vehicle is stopped briefly and the engine is switched off (e.g.
stop to fill tank).
Refrigerating temperature
control
When turned on the first time the refrigerator automatically selects the middle
thermostat position. This position can be adjusted manually using the temper-
ature range selection button (Fig. 218,7). The indicator lamps (Fig. 218,8)
show the selected thermostat position. The refrigerating temperature for all
three types of power is set with the temperature range selection button. It
takes a few hours till the refrigerator reaches its normal operating temperature.
When changing over the operating mode the thermostat setting will be main-
tained. The refrigerating temperature is retained regardless of the type of
power being used.
Frame heater (FH)
The following options are available for operating times of the frame heater:
z
2 hours
z
5 hours
z
Continuous operation (switched on for 30 minutes, then for 5 minutes on
and 5 minutes off in alternating intervals)
Setting operating time:
„
Switch on the frame heater for a 2 hour period: Push button (Fig. 218,6)
once. One bar is lit up on the temperature range display (Fig. 218,8).
„
Switch on the frame heater for a 5 hour period: Push button (Fig. 218,6)
twice. Two bars are lit up on the temperature range display (Fig. 218,8).
„
Setting frame heater for continuous operation: Push button (Fig. 218,6)
three times. Three bars are lit up on the temperature range display
(Fig. 218,8).
The temperature range display (Fig. 218,8) shows the operating time of the
frame heater for several seconds.
High external temperatures and high humidity can cause drops of water to
form on the metal frame of the freezer compartment. This is why the refriger-
ator is equipped with a frame heater for the freezer compartment. If the tem-
perature and humidity are high, switch on the frame heater by pressing the
button (Fig. 218,6). This prevents corrosion. If the frame heater is switched on,
the illuminated button (Fig. 218,6) is lit.
Manual operation
Switching on:
„
Open the regulator tap on the gas bottle and the gas isolator tap "Refriger-
ator".
„
Press and hold the On/Off button (Fig. 218,1) for about 2 seconds. The
refrigerator switches on and the previously set power type or "AES" is dis-
played.
Z
When the frame heater is turned on, it uses about 4 Watts, including in gas
operation. To avoid running down the living area battery, in gas mode
refrain from running the frame heater in continuous operation or turn the
frame heater off entirely.