Burstner A 650, Инструкция по эксплуатации

Страница: 201 / 262

201
A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN
Maintenance
12
„
Close bleeding valve.
„
Repeat this procedure at all bleeding valves.
„
Check to see if the hot-water heater warms up.
12.6.4 Position of the bleeding valves
12.7 Independent vehicle heater
Use the independent vehicle heater for 10 minutes at least once a month with
a cold engine and smallest fan settings.
Before the heating season starts, have the independent vehicle heater
checked by an authorised specialist workshop.
12.8 Replacing bulbs, external
Types of bulbs Different types of bulbs are used in the vehicle. Below, we have described how
to change the different types of bulbs.
Position of the bleeding valves
A 747-2 Drain for complete emptying under the garage flap under the vehicle at the right
On the overcab bed, right and left
In the seating group away from the direction of travel, access via the bench seat
cover
In the divan in the front area, access via the service flap
In the cabinet at the left access
In the bathroom on the radiator
On the rear bed, left and right
In the kitchen behind the drawer
In the rear to the right, access via the garage flap
X
Bulbs and light fittings can be extremely hot. Therefore, allow lights to
cool down before changing bulbs.
X
Store bulbs in a safe place inaccessible to children.
X
Do not use any bulb that has been dropped or which shows scratches in
its glass. The bulb might burst.
Z
A new bulb should not be touched with the fingers. Use a cloth when
installing the new bulb.
Z
Use only bulbs of the same type and with the correct wattage (see table
"Types of bulbs for exterior lighting").
Z
If LEDs in lights are defect, contact an authorised dealer or service centre.