Burstner A 650, Инструкция по эксплуатации

Страница: 170 / 262

170
A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN
Sanitary fittings
10
10.4 Filling the water system
„
Position the vehicle horizontally.
„
Switch on 12 V power supply on the panel.
„
If necessary, switch on the water pump on the panel.
„
Clean or disinfect water system.
„
Close the safety/drainage valve (Truma). Turn the knob perpendicular to
the safety/drainage valve and press the push button in.
If the temperature is below 6 °C, the safety/drainage valve cannot be
closed. Therefore switch on the living area heater and wait until the tem-
perature of the safety/drainage valve exceeds 6 °C.
„
Close all drain cocks. To do this, position the drain cock's rocking lever
(Fig. 185,1) horizontally or turn the drain cock's cap (Fig. 186,1) in a clock-
wise direction.
„
Close the drainage opening of the water tank.
„
Close all water taps.
„
Open the drinking water filler neck on the outside of the vehicle.
„
Fill the water tank with drinking water. Use a water hose, a water canister
with a funnel or similar for filling.
„
Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
„
Keep the taps open until the water flowing out of the taps has no bubbles
in it. This is the only way to ensure that the boiler is full of water.
X
When filling the water tank, observe the maximum permissible gross
weight of the vehicle. Luggage must be reduced accordingly when the
water tank is full.
Z
The water pump will overheat without water and can get damaged. Never
operate water pump when the water tank is empty.
Z
The Truma system (heater/boiler) has a safety/drainage valve and,
depending on the model, one or two drain cocks for emptying.
Z
Depending on the model, the Alde system (heater/boiler) has one or two
drain cocks for emptying.
Z
The water quantity can be monitored on the panel while the water tank is
filled.
Fig. 185 Drain cock (with rocking lever) Fig. 186 Drain cock (with twist cap)