Burley Surefire FCC 16, Инструкция для пользователя, установки и обслуживания

Страница: 23 / 32

Page 21
4.9.3. Connecting the Gas Supply
The gas supply to the fire must be carried out using rigid or semi-rigid metal tubing. A service
cock must be incorporated near the appliance to facilitate isolation of the fire during servicing.
An isolating valve (with a pressure test point) has been supplied with this fire.
The gas supply must be fed into the firebox through the aperture on the left hand side. Care
should be taken to sleeve the pipe when passing through masonry.
Make an appropriate slit in the rubber grommet and feed the gas supply pipe through it. Seal
the gas inlet slot with the grommet.
Connect the outlet of the isolating valve to the supply pipe leading to the control valve. The
outlet on the isolating valve is the one next to the pressure test point.
4.9.4. The Electricity Supply
If necessary install a mains socket near the appliance.
Plug the power supply / transformer unit into an adjacent socket and route the cable to the
appliance and insert the DC plug into the socket behind the fret on the left hand side of the
appliance. The cable should be installed through a conduit sufficiently large to accommodate
the DC plug so that replacement of the power supply / transformer unit is possible. The fan is
switched automatically as the fire warms and cools.
Note; The power supply unit is supplied with a selection of DC plugs. Choose the
one that fits the socket on the fire and connect it to the socket on the lead from
the PSU with side showing centre positive next to the arrow
.
4.9.5. Coal Effect Layout
The fire is supplied with a set of ceramic fuel bed components as follows:
A three piece set of: lining boards, one left hand side, one right hand side and a rear board.
One Moulded Front Ceramic, Moulded Base Ceramic, Moulded Coal Matrix, Coal with round
peg and one Coal with square peg.
Place the ceramic components as follows:
Hold the rear board in position and then place the left and right side boards in position with the
curved edges upwards and the black faces visible.
Position the Base burner ceramic in position behind the rear burner flange.
Place the front burner ceramic in its support in front of the burner. Ensure that the front
ceramic slides in easily and is upright.