Burley Surefire FCC 16, Инструкция для пользователя, установки и обслуживания

Страница: 21 / 32

Page 19
4.9. Installation Procedure
Before commencing installation, ensure that the intended installation will comply
with details in
General Information on Pages 2 and 5 .
The Burley Magiglo FCC 16 is designed to be inset into a 16” fireplace opening. Any surround
that is to be installed with this appliance must be rated at 150oC.
The installation of this appliance must be carried out by a competent person in accordance
with the current Gas Safety (Installation and Use) Regulations (as amended). It is mandatory
that all gas installers are Gas Safe registered.
4.9.1. Preparing for the Installation
Carefully unpack the contents of the carton and check
them against the checklist given on the previous page.
Make sure that the fireplace opening is suitable for the
installation of the fire and prepare the fireplace to suit
the dimensional requirements given in section
4.6 (i.e.
fitting the fire surround, the hearth (if required) etc.).
Apply the sealing strip around the rear edge of the
flange.
Remove the louvre panel secured by three screws and
then the four screws holding the upper glass clamp,
remove the glass panel. Store the louvre and glass
panels in a safe place during the installation process.
4.9.2. Installation of the Firebox
1. Mark out, drill, plug and fit the two eye screws onto the rear wall of the fireplace opening
as shown below. Thread the cable through the lower hole in the (right hand) side of the
firebox and then out of back hole. Place the appliance close to the fireplace opening and
feed the cable through the two eye screws and then back into the upper hole in the back
of the firebox. Whilst pulling the cable push the firebox gently into the opening until its
flange meets the fire surround.
2. Slide the short piece of 8mm tube way onto the cable followed by the tensioning screw.
3. Whilst holding the cable tensioning screw pull the cable taught and without releasing the
tension tighten the thumb screw firmly. To further tighten the cable screw the wing nut
clockwise.
4. Roll up the excess cable and tuck it away. DO NOT CUT OFF the excess cable. Ensure
the excess cable does not foul the flap mechanism.
5. Remove the grommet from the gas inlet slot on the firebox to allow for gas pipe to come
through. (Ensuring that the gas pipe emerges from the slot at the left hand side of the
appliance).