10
User Instructions
WARNINGS
1. Read the instructions before using this appliance
.
2. This appliance requires installation and annual servicing by a CORGI registered installer.
3.
Use only in a correctly sized and ventilated area.
4. Any purpose provided ventilation should be checked regularly to ensure it is free from
obstruction.
5. Once the logs have been positioned in accordance with the installation instructions; they must
not be moved except for servicing.
6. The surfaces of the appliance become very hot during use.
7. If necessary the casing should be wiped with a cloth dampened in soapy water. Do not attempt
to touch or wipe the fire whilst it is hot, doing so could result in damage to the paint finish and
severe burns. Do not use any chemical cleaning agents or abrasive cleaners to clean the paint
work of the fire as this may result in damage not covered by the guarantee. If the paint becomes
damaged or worn, special touch up paint is available from our service department on 01572
756956. Do not use any other type of paint.
GENERAL REQUIREMENTS
1. The heater is intended as a secondary heat source. Check that a primary source of heat (such as
radiators) is present in the room. If insufficient primary heat is being used there may be a build up
of condensation.
2. The heater must not be used on or against a combustible surface. No furniture or curtains must
be close to the appliance (or at risk of being blown close)
3. In the event of gas leakage, the gas supply must be turned off and advice sought.
4. The guard on the appliance is to prevent risk of fire or injury from burns and no part of it may be
permanently
removed. It does not give full protection for young children, the elderly or infirm. Parts of the
appliance get hot,
it is strongly recommended that an additional guard to BS6539 or BS6778 is used in the presence of
children
the elderly or infirm.
5. This is not a drying appliance. Do not place clothing or other articles, on or against it.
6. Do not store or use flammable substances on or near the heater.
7. Do not spray aerosols on or near the heater.
8. If any material, such as plastic, melts on the surface of the glass, turn the heater off and allow it
cool. Do not remove the
