4
PANEL PRO
The Panel Pro shipping crate contains the following items:
1.
The Panel Pro base, x,y, and z axis assemblies
2.
4 legs to be attached by user
3.
3 stepper motors and motor to lead screw couplers for X and Y axis.
4.
1 stepper motor with knob and coupler for Z axis.
5.
3 1/2hp Milwaukee router with ER11 adapter installed.
6.
SC3 controller
7.
5 gallon coolant tank (drain & filter housing in tank for shipping)
8.
Submersible coolant pump
9.
AC power cord, X axis & YZ axis controller cables, and USB cable
10.
Tool kit with various tools, starter supply of end mills, etc.
11.
Software-AvCAM & EasyCAD, and Drawing Library (inside the 3 ring binder)
12.
Optional Measure Pro.
13.
Optional EG2 engraver.
14.
Optional Diamond engraver.
15.
Optional King air panel spacer kit.
This manual is intended to help with set up and get you started with operation.
Detailed function and operating information can be found in the AvCAM help file.
Training
While most of our users are able to learn Panel Pro operation by careful study of the
paper manual and help file, training is available either at your location or ours. For new
machine owners, we can train at your continental U.S. facility for direct expenses
incurred. You are welcome to travel to our facility for no charge training. Call us if you
would like to schedule training 701-255-7640.
SETTING UP THE PANEL PRO
Planning the area:
You should have enough room for access on the front side (the deep side of the drain
pan), left and rear sides.
The computer should be on a table that is located at a
