36
5000_h
5000_h
PANEL PRO
Do the same with the lower edge of the ATI hole measured from the lower edge of the
panel. We can use these temporary lines to line up the instrument we wish to insert.
temporary vertical line
temporary horizontal line
offset horizontal line
6. 780
0. 854
temorary vertical line
You can now draw a construction line from the center of the instrument and then draw
offsets from that to place other instruments on the same vertical or horizontal
centerline. If you have two intersecting lines you can place an inserted instrument
(instruments have there 0,0 point in the center) by clicking mod>intersection or F6,
then clicking on the intersection of the two lines you want to place it on.
Another technique, to adjust an instrument
so that it moves directly onto an existing
line, in the illustration below, we want to
move the instrument so that it is directly on
the vertical line. Click edit > move, click the
instrument you want to move, right click. It
will ask where you want to move from. Hit
F4 (center) then click on the circle that
defines the instrument hole. You will be
asked where to move to. Hit the F6 key
(intersection). Click on the vertical line, then click on the horizontal line that comprises
the center mark of the instrument. The instrument will move from the center of the
instrument to the intersection of the vertical line and the horizontal line of the center
mark.
