Bull DPS7000/XTANOVASCALE 7000 180Rb 7, Руководство по обслуживанию, Страница: 184 / 258

4-74 Disassembly and Reassembly
Rack Rails Kit
Use the following procedure to install the new type of two-hole T-brackets on to
the rack slide rail assemblies.
1.
Remove the new two-hole T-brackets from the rack rails kit.
2. Remove the three hex nuts securing the four-hole T-bracket to the front of
the left-hand rail assembly. Discard the four-hole T-bracket.
See Figure 4-55.
Note:
The non-captive screw is accessible from the rear
of the left-hand rack rail by fully extending its center rail.
A
B
A. Non-captive screw
B. Captive screws (2)
Figure 4-55. Removing the Front Left-Hand Four-Hole T-bracket
3. Install the new two-hole T-bracket from the rack rails kit to the front of the
left-hand rack rail by using the three hex nuts and screw removed in the
previous step. See Figure 4-56.
Note:
To identify the front left-hand two-hole T-bracket
the number 1 is stamped on the side of its metal surface.
See Figure 4-56.