LinkStation User Manual
162
Appendix
The Info/Error LED blinks red to indicate an error.
The error may be identified by the pattern of blinking.
Note: – The error may also be viewed from NAS Navigator2.
Error code
Error details
E00
MPU is abnormal; no power.
E01
DRAM data line is abnormal.
E02
DRAM address line is abnormal.
E03
RTC chip is abnormal.
E04
Kernel failure.
E14
The RAID array cannot be mounted. Turn off power, then turn power on again.
If the same error is displayed, re-configure RAID.
E15
I/O error of hard drive.
E16
The hard drive is not connected, or data transfer has failed.
E17
Controller error.
E21
Controller error.
E23
The hard drive has crashed.
Place
Status
10’s place
The LED illuminates for 1 second every 0.3 seconds.
The number of flashes is the ten’s place of the error code.
1’s place
The LED illuminates for 0.5 seconds every 0.3 seconds.
The number of flashes is the one’s place of the error code.