Buell 2002 S3T, Руководство по обслуживанию, Страница: 67 / 450

2002 Buell S3T: Maintenance 1-39
HOME
HEADLAMP 1.22
INSPECTION
1
WARNING
1
WARNING
DO NOT modify the ignition/headlamp switch wiring to
circumvent the automatic-on headlamp feature. Riding
without an operating headlamp could cause an accident.
Failure to comply could result in death or serious injury.
Check headlamp for proper height and lateral alignment:
●
When the new owner takes delivery of the motorcycle.
●
When there is a change in load (adding luggage, etc.)
1. Verify correct front and rear tire pressure. See 1.8 TIRES
AND WHEELS .
2. Place motorcycle on level floor (or pavement) in an area
with minimum light.
3. See Figure 1-53. Position motorcycle 25 ft (7.62 meters)
away from a screen or wall. Measure the distance from
directly below the front axle to the base of the screen/
wall.
4. Draw a horizontal line 32 in. (81.3 cm) above floor on
screen/wall.
5. Load vehicle with rider/passenger/cargo/accessories.
Weight will compress vehicle suspension slightly.
6. Stand motorcycle upright with both tires resting on floor
and with front wheel held in straight alignment (directly
forward).
7. Turn ignition switch to IGN. Set handlebar headlamp
switch to HIGH beam position.
8. Check light beam for alignment.
a. The main beam, which is a broad, flat pattern of
light, should be centered equally above and below
the horizontal line.
b. The main beam of light should also be directed
straight ahead. Properly adjusted headlamps project
an equal area of light to right and left of center.
c. Adjust headlamp alignment if necessary. See
ADJUSTMENT .
ADJUSTMENT
See Figure 1-54. The headlamp adjusters are located behind
the dash panel.
For Vertical Adjustment:
Turn adjuster on the left side of headlamp mounting stud
clockwise to raise beam or counterclockwise to lower beam.
For Horizontal Adjustment:
See Figure 1-55. Use a nut driver on the right side headlamp
mounting stud clockwise to aim beam to the right or turn the
stud counterclockwise to aim beam to the left.
Figure 1-53. Checking Headlamp Alignment
Figure 1-54. Headlamp Adjusters
Figure 1-55. Headlamp Horizontal Adjustment
25 ft
(7.62 meters)
b0008c7x 32 in.
(81.3 cm)
b0587xox
Headlamp Adjusters
6239
Stud
Nut Driver