Buell 2002 S3T, Руководство по обслуживанию, Страница: 324 / 450

2002 Buell S3T: Fuel System 4-109
HOME
NOTE
Air cleaner support ring fits around rear breather bolt. Fitting
on rear breather bolt may not clear the frame if bolt removal is
attempted. Do not remove the rear breather bolt unless abso-
lutely necessary.
12. Before the backplate is removed, unseat the IAT sensor
wiring grommet from the backplate. Gently pull the IAT
sensor wiring through the backplate.
INSTALLATION
1. Slide the IAT sensor wiring through the hole in the back-
plate. Seat the grommet inside the backplate.
2. Install backplate.
a. Apply HYLOMAR to breather bolt threads. If
removed, install air cleaner support ring.
b. See Figure 4-108. Slide rear breather hose (3)
through backplate (5). On California models, slide
canister fresh air inlet hose from carbon canister
through backplate.
c. Install a new breather gasket behind backplate.
d. Install front breather bolt (4). Tighten to 10-15 ft-lbs
(14-20 Nm).
3. Apply LOCTITE THREADLOCKER 243 (blue) to spacer
screw (2). Install spacer and gasket (1) using spacer
screw (2). Tighten to 7-9 ft-lbs (10-12 Nm).
4. See Figure 4-107. Apply LOCTITE THREADLOCKER
243 (blue) to bolts (1). Insert bolts (1) through backplate
and mount. Install nuts (2). Tighten to 3-5 ft-lbs (4-7 Nm).
5. Attach IAT sensor to snorkel. See Figure 4-105.
6. See Figure 4-106. Install snorkel.
a. Apply LOCTITE THREADLOCKER 243 (blue) to
screws (1).
b. Align snorkel (3) on spacer (4) and spacer screw.
c. Attach snorkel to backplate assembly using snorkel
plate (2) and two screws (1). Tighten to 6-8 ft-lbs (8-
11 Nm).
7. See Figure 4-103. Install front breather hose (3) on front
breather bolt (2). Attach rear breather hose (1) to
breather tee (4).
8. Inspect filter element. See 1.18 AIR CLEANER .
9. See Figure 4-103. Place filter element in filter box (2).
Attach filter box to snorkel (1).
10. Apply LOCTITE THREADLOCKER 243 (blue) to bolts (3).
Fasten filter box to backplate with bolts and washers (3).
11. If removed, attach right fairing lower to air cleaner cover
using two mounting bolts and washers.
12. See Figure 4-102. Place cover (3) over backplate
assembly. Install both rear screws and nylon washers
(1).
13. Install both front screws and nylon washers (2).
14. Install bolt and washer to fasten right fairing lower to
bracket on swingarm/drive support.
Figure 4-105. IAT Sensor
6769
Catch
Figure 4-106. Air Cleaner Front Mount
Figure 4-107. Air Cleaner Front Mount
Figure 4-108. Air Cleaner Spacer
6226
Screw
Screw
Snorkel Plate
Snorkel
Spacer
6227
Bolt
Nut
1. Spacer and Gasket
2. Spacer Screw
3. Rear Breather Hose
4. Front Breather Bolt
5. Backplate
6224
2
1
3
4
3
5