Buell 2002 S3T, Руководство по обслуживанию, Страница: 114 / 450

HOME
2-40 2002 Buell S3T: Chassis
12. See Figure 2-62. Place a jack under the crankcase.
13. Detach rear tie bar from swingarm.
14. See Figure 2-63. Remove left and right isolator bolts and
washers (7).
CAUTION
Do not attempt to raise frame with oil filter installed.
Remove oil filter before raising frame. Failure to comply
may result in damage to oil filter.
15. Place a drip pan under the oil filter. Remove oil filter.
16. Using floor hoist, raise frame enough to remove both
rubber isolators (6) from frame mounted pins.
17. Loosen swingarm pinch screw (4) on right side.
18. Remove threaded rod (1) from between bearing adjust-
ing bolts (2, 3).
19. Loosen remaining swingarm pinch screw.
20. See Figure 2-64. Using floor hoist, raise frame while
pushing down on swingarm. Frame must be raised until
bearing adjustment bolts (2) clear pin on frame and can
be removed.
NOTE
If swingarm mount block doesn’t drop from frame as lift is
raised, insert the REAR ISOLATOR REPLACEMENT TOOL
(Part No. B-44623) between mount block and frame on the
right side first. NOTE: Ledge on tool should engage top of
mount block. See
Figure 2-72.
21. After removing both bearing adjustment bolts, remove
swingarm.
INSTALLATION
1. See Figure 2-63. Align new swingarm between posts on
swingarm mount block (5).
2. Insert left (threaded) and right bearing adjustment bolts
(2, 3) into swingarm until flush with mount block surface.
3. Tighten left side swingarm pinch screw (4) to 18-20 ft-lbs
(24-27 Nm).
4. Install threaded rod (1).
a. Apply LOCTITE THREADLOCKER 222 (purple) to
threaded rod.
b. Insert threaded rod through right side bearing
adjustment bolt (2) into threads on left side bolt (3).
c. Verify that swingarm is centered between mounts.
d. Tighten rod to an initial torque of 11-12 ft-lbs (15-16
Nm).
5. Check swingarm preload using a scale as shown in Fig-
ure 2-65. Preload should be 3.0-3.75 lbs (1.36-1.70 kg).
If preload does not meet specifications, tighten or loosen
threaded rod and recheck.
Figure 2-62. Scissors Jack
Figure 2-63. Swingarm Assembly
6875
1. Threaded Rod
2. Bearing Adjustment Bolt (Right)
3. Bearing Adjustment Bolt (Left, Threaded)
4. Pinch Screw (2)
5. Swingarm Mount Block
6. Rear Isolator TORX Bolt and Washer (2)
7. Rear Isolator (2) (Typical)
Threads
b0632xsb
1
7
4
3
2
5
6