4
Placing the boiler
Logano GB125 BE US/CA - Subject to technical modifications.
15
4.2
Reversing the burner door
The burner door is factory-installed with the hinges on the
right – the burner door opens to the right. You can change
the burner door hinges over to the left-hand side if
required to suit the installation site.
Requirement: the burner hood must have been removed
first (
Æ
Chapter 3.1, page 12).
B
Removing the burner door (
Æ
Chapter 3.1, page 12).
B
Unscrew the hex bolts [1] and remove the hinge pins
[2].
B
Fix the hinge pins [2] on the left-hand side of the boiler
using the hex bolts.
Fig. 9
Reversing the burner door (boiler block
attachments)
1
Hex bolts
2
Hinges
B
Unscrew the hex bolts [1] and remove the hinge barrels
[2].
B
Fix the hinge barrels [2] on the left-hand side of the
burner door [3] using the hex bolts.
B
Hang the burner door [3] by locating the hinge barrels
[2] on the hinge pins [4].
B
Check that the heat exchanger baffles are placed
horizontally (
Æ
Chapter 6.3, page 32).
B
Close the burner door [3] and secure with the two hex
bolts. Tighten the hex bolts evenly (approx. 90 lbs in) so
that the burner door seals properly.
Fig. 10 Reversing the burner door (door attachments)
1
Hex bolts
2
Hinge barrels
3
Burner door
4
Hinges
5
Heat exchanger baffle plates
7 747 019 141-08.1RS
1 2
2 1
If the burner door hinges have been changed
over to the left-hand side, the burner cable
must be disconnected from the burner before
opening the burner door.
7 747 019 141-09.1RS
1
4
5
2
3
