9
Installing the control panel
Logano G615 - Subject to technical modifications
40
Connecting power supply
Fig. 51 Fastening the connecting cables
1
Sensor wells
2
Sensor retaining clip
3
Cable entry
4
Cable strain relief
B
Connect the electrical cables as shown in the wiring
diagram. Take care to ensure proper cable and
capillary tube routing.
B
Insert cable strain relief with cable inside into the clip
frame and secure by closing the lever.
Mounting rear panel and terminal cover
B
If necessary, break away section from the rear panel.
B
Engage the lower hook of the rear panel section with
the frame at an angle and tilt upward until the upper
hooks engage with the side panels.
B
Put the top cover in place and tighten the screws.
Fig. 52 Mounting the rear wall section
1
Side hooks
2
Rear panel section (control panel)
Hard wire the control panel to the building
power supply following recognized
standards such as EN 50165 and local code,
rules, and regulations.
Secure all cables with cable strain reliefs.
2
1
6 720 642 625-46.1o
