Explanation of the control unit
4
Logamax plus GB162-65/80/100 - Subject to modifications resulting from technical improvements!
11
Maximum CH (boiler) flow temperature dial
The maximum CH (boiler) flow temperature (fig. 6,
item 8
) is used to set the upper CH (boiler) flow
temperature limit. The unit is °C.
Display
The heating system status and values can be read out
from the display (fig. 6,
item 9
). If a fault occurs the dis-
play will immediately show the accompanying fault code.
The fault code display will flash if a locking fault is
detected.
DHW temperature dial
The DHW temperature dial (fig. 6,
item 11
) is used to
select the required temperature of the hot water in the
hot water cylinder. The unit is °C.
"DHW mode" LED
The "DHW mode" LED (fig. 6,
item 10
) lights up when
a DHW request has occurred and it is extinguished
when this DHW request is no longer required.
fig. 6
BC10 basic controller
1
2
3
4
5
6
7
11
10
9
8
DAMAGE TO THE INSTALLATION
with underfloor heating: by the floor being
overheated.
Limit the maximum CH (boiler) flow
temperature using the "CH (boiler) flow
temperature" dial (fig. 6,
item 8
) to the
permissible flow temperature of the floor
heating circuit (usually maximum 40 °C).
