Additional programming options
8
Logamatic 4321/4322 - Technical specifications are subject to change without prior notice.
62
8.3
Creating a new DHW program
You may operate DHW heating either according to the factory settings "program
selction heating zone" or according to your own new switching program
"program selction custom DHW".
If DHW is to be heated independently of the heating zones, you can enter your
own new DHW program as follows:
Example:
On all weekdays DHW should be heated from 6:30 am until 9:00 am (06:30 h
until 09:00 h).
z
Select a heating zone (
Æ
Chapter 7.6).
(here: "DHW")
z
Select a program for the heating zone "DHW" (
Æ
Chapter 7.10).
(here: "program selction new")
The display shows the blank mask "new set point" for the new set point.
z
Enter the set points (
Æ
Chapter 8.2).
DHW heating will now operate according to your "custom program DHW". You
can call up your new "custom program DHW" by pressing "PROG" and turning
the dial (
Æ
Chapter 7.6).
USER NOTE
With the factory setting
"program selction heating zone", DHW is heated
30 minutes prior to the first set point of all heating zones associated with this
control panel, and ends when the last heating zone is switched off.
new set point
--------------
----
at ---
USER NOTE
Only after all three details (day/time/temperature) have been defined for the
new set point will it be automatically saved under "custom program DHW", and
the heating zone selection "DHW". The saving process is not shown on the
display. The display shows the blank mask "new set point" for the next set
point. Repeat this process for all desired set points.
