KTF/100HPS Operation
KTF/100HPS
- 3-15 -
P3 Programming Level
LFA m/min
#
ADVANCED
#
MENU P3
The P3 programming level allows you to setup 4 functionality:
1)
Offset reading/execution and Auto Offset enabling;
2)
Device operation mode;
3)
Access code to programmable function;
4)
KTF identification code.
to select the P3 level.
to continue.
P3.1
OFFSET
This function is used to adjust the mechanical clamping position of KTF/100HPS
device. It clears possible measurement errors due to the different clamping position
of the KTF/100HPS on textile machine. The displayed indication is the
actual
OFFSET
value resulting from the clamping position of the KTF/100HPS. While
lifting the yarn above the load cell, press
to check whether the
stored
OFFSET
value corresponds to the
actual
OFFSET
value. If the two values are different, press
to align them.
to select the next parameter.
Keeping pressed
for 3 seconds, enables the “Automatic Offset” function and
the display shows
OFFSET AUTO
.
!
For more details about the Automatic Offset function, please refer to
“Functions Directly Available to the Textile Machine Operator”, page 3.3.
P3.2
MODE
Here you can select the different working modes of INC/DEC commands.
[Mode: 00, 01, 02, 03], or a special working mode [Mode 04] which provides the
possibility to feed the yarn in both directions.
Choose the desired working mode using
or
to select the next parameter.