register
regi_star_MA_Kap_3_en
Rev. 1.2.1 - 08/2014
14
Assembly Instructions
• Mount the shaft encoder, depending on the type of drive, on the main
drives or on the counter pression cylinders shaft.
• The shaft encoder must be mounted in a transmission ratio corres-
ponding to the application (e.g. 1:1).
• The shaft encoder must be mounted so that no slip can occur.
Assembly
Conduct the following steps in order to mount the shaft encoder:
• Mount the shaft encoder flange (
A,
not included in the
eltromat
scope
of delivery) on the machine side.
• Plug the shaft encoder coupling (
B
) on the cylinders shaft end (or
on the deviation rolls end) and tighten it.
• Plug the shaft encoders shaft (
C
) in the shaft encoder coupling.
• Adjust the shaft encoder axially aligned and tighten it on the shaft
encoder flange.
STOP!
Consider the maximum offsets in order to avoid a damage on
the shaft encoder coupling:
• radial: max. arbour offset 0.2 mm
• axial: max. arbour offset 1 mm
• angle offset: max. 2
°
• Tighten the shaft encoder coupling on the shaft encoder shaft.
• For further advice on mounting the shaft encoder and the coupling,
please see the provided documentation.