register
regi_star_MA_Kap_3_en
Rev. 1.2.1 - 08/2014
10
In addition, the required space for the respective traverse bar type is
indicated in the illustration.
Fig. 3.2
All relevant information on your register controllers traverse bar
type can be found in the customer documentation under MECHANICAL
DRAWINGS.
Assembly Methods
There are three different methods to assemble the traverse bar. There
is a special end piece on the traverse bar which depends on the assembly
method.
Winding
: There must be M10 tap holes at the traverse bars front face.
The traverse bar is fixed with an M10 screw. For assembly, a suitable
drill-hole must be made on the machine stand.
Round shank
: For assembly, a compatible counter piece must be present
on the machine stand.
Flattened round shank
: For assembly, a compatible fork piece must be
present on the machine stand.
Safety Instructions
WARNING!
Guarantee security at the traverse bar assembly location
before starting the assembly works. During the entire assembly works,
the printing press must be fully stopped and secured against restart.
Possible consequences of non-observance can be death or serious injury.
ATTENTION!
In order to avoid accidents or damages, a
second person
is needed to transport or to assemble the traverse bar.
ATTENTION!
Danger of crushing! When transporting the traverse bars,
make sure that the sled for lateral adjustment has been fixed with the
release handle. Injury can be consequence of non-observance.
When choosing the assembly location, consider the machine categories
of the register sensor and of the traverse bar (if applicable)! Further
information on this issue can be found in the register sensors operating