Page 22
BSS-Streaming Service
BSS-Case
Do not connect batteries that do not meet these requirements. There is a risk
of overheating, short circuit and fire.
Optionally, you can operate the case with the car adapter cable
ART-000325 via a 12V on-board power socket or the cigarette lighter.
When connecting to an on-board voltage socket, make sure that it pro‐
vides 12V/5A. Attention, on-board voltage sockets in trucks are often
operated with 24V!
Voltages greater than 14.4V can damage or destroy the control electronics in
the BSS case.
The on/off switch on the front of the housing switches both mains and
battery voltage. As long as mains voltage is present, the electronics give
priority to this. As long as there is no mains voltage, in the event of a
power failure or when the mains plug is removed, the electronics auto‐
matically switch to battery
power. As soon as the case is
powered by battery voltage,
the red LED on the front of the
case lights up.
Overload safety fuse
If 5A or more are constantly
consumed by the connected
devices, the overload protecti‐
on on the front can trigger. In this case, disconnect unnecessary consu‐
mers (e.g. from the USB charging port) from the power supply and press
the fuse safety button back after a short cooling phase.
Reverse polarity protection
The built-in Case on-board electronics have reverse polarity protection.
In rare cases, it can be the case with vehicle on-board voltage sockets
that these lead to ground (-) on the pin contact instead of +12V. If, after
connecting the case to an on-board voltage socket, no function of the
devices is apparent, please check this possibility as well.
(Image 21) LED & fuse for the battery sup‐
ply on the front
Page 23
Using the adapter cable ART-000326 with its open cable end, various
customer-specific plugs can be assembled for connection to a 12V DC
voltage source. Please note that all plugs or connecting elements used
must be approved by the manufacturer for at least 5A continuous cur‐
rent.
Pay attention to the type of attachment described by the manufacturer
in order to minimize contact resistance and ensure a safe current flow.
Wire color at the open end: brown = +12V ; blue = ground
3/8" mount (ATEM Mini option)
The case can be attached to tripods, tubes and the like via the 3/8 inch
attachment on the bottom of the housing.
It is attached using a 3/8 inch UNC thread, which is a common type of
attachment in photo and video technology.
The minimum screw-in depth is 15mm, the maximum tightening tor‐
que (with lock nut) is 20Nm.
The maximum load values of the case when assembled can be taken
from the following sketch. These are 75N from the vertical at the front
and side edges.
Monitor settings
ATEM Mini Economic
ATEM Mini Basic /- Pro‐
fessional
The field monitor in the
case for the ATEM Mini
Basic or Professional has
its own power switch on
(Image 22) Max. load: F = 75N
Operating instruction EN
DOC-000001
