Page 18
BSS-Streaming Service
BSS-Case
have to repeat this process several times until the ATEM finds its pressure-free
seat.
With the ATEM Extreme, the counter-pressure when used is correspondingly
higher due to the almost double number of cables. However, please also note
the above-mentioned conditions for assembly.
Place the two ATEM C-clamps on the ATEM Mini / Extreme and screw
them together using a Phillips screwdriver, size PH1, with the screws
M3x8mm (6 pcs. ATEM Mini; 8 pcs. ATEM Extreme;), max. tightening tor‐
que 0, 2Nm (! apply only slightly) (picture 14)
Start up
Turning on/off
Before switching on, open the
case and open the lid com‐
pletely. The BSS case has an in‐
ternal power supply unit (max.
5A). For the power supply, plug
in the supplied power cable on
the left side of the case.
The on / off switch is located
on the front of the case (Image 14). When it is switched on, the ATEM
Mini is switched on at the same time. The field monitor must be started
by using the separate on / off switch on the top.
Note: Always turn off using the on / off switch before closing the case and
then pulling the power plug! Otherwise there is a risk of overheating / de‐
struction of the built-in devices when the BSS case is closed while switched on.
The device is switched off by manually switching off the field monitor at
its on / off switch on the top of the housing. Then turn off the switch on
the BSS case.
(Image 15) On, off switch on the
front
Page 19
Before closing the case, make sure that all built-in devices are switched
off. Close the case lid and remove the power cord.
Cooling
Integrated fan
The BSS case has a built-in fan to cool the built-in components. It is lo‐
cated on the right-hand side of the case and must never be blocked.
Make sure that no objects penetrate through the ventilation grille and
block the fan. Make sure there is enough free space (at least 15 cm)
around the outlet opening of the fan.
Vents
There are ventilation slots on
the cover plate to the right and
left of the ATEM Mini (Image 15).
Under no circumstances may
these be covered, masked or
otherwise reduced or blocked in
their cross-section. Otherwise
there is a risk of overheating /
destruction of the built-in components.
Note: Do not expose the BSS case to direct sunlight, otherwise there is a risk of
the components overheating.
(Image 16) BSS case ventilation slots
Operating instruction EN
DOC-000001
