Page 16
BSS-Streaming Service
BSS-Case
Installing the ATEM Mini / Extreme
Safety note: Before doing any work on the BSS case, pull the mains plug out of
the socket!
Do not touch the built-in electronic components when the installation slot is
open. Even when the mains plug is unplugged, these can remain live for a
long time and cause an electric
shock.
Risk of tipping: When installing
the ATEM Mini Extreme yourself,
there is an acute risk of tipping
over after opening the lid in its
end position. Only after installing
the ATEM Mini does the case re‐
ach the balanced center of gravi‐
ty.
Therefore, when opening the cover, hold the case in a horizontal position
with the help of a second person until the ATEM Mini Extreme has been instal‐
led.
The installation of the ATEM Mini requires technical understanding and
some manual skill. Please con‐
tact our service team if you need
assistance with the installation.
Required tools: Phillips screw‐
driver, size PH1
Plug in the cables
First remove all transport locks
and protective covers from the
(Image 12) Plug the cable into the ATEM
(Image 11) Danger of tipping over
if ATEM Extreme is not installed
Page 17
installation recess. Use the screwdriver to remove the two C-clamps (6x
M3x8 ATEM Mini Case / 8x M3x8
ATEM Extreme Case ) that are
mounted to the left and right of
the recess.
The ATEM Mini / Extreme is swi‐
veled into the recess provided
from above and fastened with
the enclosed C-rails. First plug in
all the cables to the ATEM Mini /
Extreme (Image 12). These are all
labeled in the same way as prin‐
ted on the ATEM Mini / Extreme. Hold the ATEM Mini / Extreme with one
hand and plug in the cables from left to right, starting with the micro‐
phone connectors.
Note: Never pull the cables with force, as this could damage them.
The ATEM Mini / Extreme is inserted by swiveling the back into the re‐
cess (image 13).
Due to the large number of cables that are used at the same time, it
may be necessary to insert them one by one, twisting them slightly.
Make sure that the cables have enough space to find their place under
the cover without much counter-pressure.
Note: Work carefully and never
force the ATEM Mini into the re‐
cess! If you feel too much back
pressure or if the cover plate de‐
forms under the pressure of the
cables, carefully remove the
ATEM Mini / Extreme and sort
the cables again until the ATEM
Mini / Extreme can be inserted
into the recess without too
much counter pressure. You may
(Image 14) Screw ATEM Mini with C-
clamps
(Image 13) Swing in the ATEM Mini
Operating instruction EN
DOC-000001
