Page 30
BSS-Streaming Service
BSS-Case
Technical specifications
Conditions for proper use
Electrical connected load
Electrical connection values battery voltage
Maximum screw tightening torques
Description
Screw size
Maximum torque
ATEM-Cover
DIN 7380 M4x12
0,3 Nm
Screen screw connection
DIN 7380 M4x12
0,4 Nm
ATEM C-clamps
ISO 7380 M3x8
0,2 Nm
Supply voltage
= 12 - 14,4V/5A
Power
60 W
Temperature range
+5° – +40° C
Relative humidity
20 – 90%
No condensation
Storage temperature
-20° – +60° C
Do not use at altitudes over
2000m above sea level
Do not operate in a dusty
environment
Supply voltage
~230V/16A
Power
60 W
Page 31
Troubleshooting
Occurred error
First action
Further action
The built-in
components do not
work.
Check if the power plug is
plugged in properly.
Turn on the on/off
switch on the BSS case
again.
Check whether mains
voltage is present.
Plug into a different
outlet/circuit.
With battery operation
- the built-in
components do not
work
Check for battery voltage.
(is the LED on the front
lit?)
Remove all connected
consumers (e.g. at the
USB port) and turn the
on/off switch on again.
The screen doesn't
work.
(ATEM Mini only)
Turn on the screen by
pressing the power
button (top right) for >5
seconds.
Check that the 12V DC
power connector on the
screen (bottom left) is
properly plugged in.
The fan is not running
Switch off the BSS case,
disconnect it from the
power supply and check
whether a foreign object
is blocking the fan (visual
inspection).
Carefully remove the
foreign body from the
outside. Otherwise
contact our service.
A connected device is
not recognized on the
ATEM Mini / Extreme.
Ensure that the
appropriate interface on
the device is enabled and
compatible with the
required ATEM input
values.
For HDMI input signals:
Change the HDMI input
on the BSS case and/or
swap the HDMI
connection cable.
Operating instruction EN
DOC-000001
