Brütsch Rüegger 148 460, Руководство пользователя

Страница: 101 / 187

6 - 3
No. 99MBB079A
6. SAVING/OUTPUTTING/COMMUNICATING THE MEASUREMENT RESULTS
6.2 Saving/Calling/Deleting Measurement Results
The SJ-201P can save measurement results up to 10 cases. Also, it can call the saved data
and delete data from memory.
6.2.1 Saving measurement results
The SJ-201P is equipped as standard with the built-in memory that can save up to 10 cases of
measurement results.
One of the data numbers 1 to 10 is appended in ascending order to each of the saved mea-
surement results. If more than 10 cases of measurement results are to be saved, data numbers
are repeatedly used from 1 as saving destinations. At the same time, the surplus existing
measurement results are deleted from data number 1.
1
→
2
→
3
→
• • • •
→
9
→
10
→
1
→
2
→
• • • •
•••
••
Data No.1 is used again at the time the
eleventh measurement result is saved.
TIP Even if measurement results have been saved, all saved data is cleared in the
following cases.
•
The SJ-201P power supply cannot be turned on due to low level power of the
built-in battery.
• The SJ-201P is used with the built-in battery switch being off, or the built-in
battery switch is turned off.
• All saved data has been deleted. (Refer to "6.2.3 Deleting the Saved Data".)
■
Procedure for saving measurement results
1. Before performing measurement, set "Save" (or "SPC Output & Save").
Set the measurement result
output mode to 1 (or 2).
TIP For information about measurement result output setup, refer to "6.1 Setting the
Measurement Result Output".
2. Perform measurement.