47
Technical data
and start-up
NLG5 charger
7
Installation / Start-up
7.1
Installing and Connecting the Charger
DANGER
High voltage!
Danger to life!
During the assembly of the charger, not adhering to the connection sequence can pose a danger to
life through electric shock!
Before starting work, make sure the absence of voltage in the HV-circuit!
You must follow the given operating sequence!
Under no circumstances should you carry this out in a careless or rash manner!
INSTRUCTION
When connecting the battery cable to the HV battery, a precharging resistor must be used!
Connecting without a precharging resistor can lead to very high current peaks which can in turn lead
to damage to the charger!
INFORMATION
Visually check the packing material and the charger itself in particular for damages before
installation. Each charger undergoes a strict quality and function test at BRUSA before distribution.
However, we have no control over transportation routes which can sometimes take a long time and
the shipping of our products.
PROCEDURE STEP
ILLUSTRATION / OTHER INFORMATION
1.
Integrate the charger mechanically into the specified
position.
Use the screws and torques stated, see
chapter
---
2.
Connect the cooling water pumps (only with the
water-cooled version).
See chapter
---
3.
Ventilate the cooling water system.
Make sure that no air pockets are available in
the cooling system!
4.
Make the ground connection between the charger
and the vehicle.
As short a cable length as possible should be
selected.
---
5.
Build the
control plug
cable connections.
---
