BRP Evinrude, Руководство по установке

Страница: 79 / 100

77
FUEL AND OIL PRIMING
OIL REQUIREMENTS
4
OIL REQUIREMENTS
Recommended Lubricants
Evinrude/Johnson XD100, XD50 , or XD30 out-
board oils are recommended for use in Evinrude
E-TEC outboards. If these oils are not available,
you must use a TC-W3 certified oil.
Evinrude/Johnson XD100 outboard oil is highly
recommended for all conditions and applications.
Engine Lubricant Below 32°F (0°C)
If the outboard will be operated in temperatures
below freezing (32°F, 0°C), use
Evinrude/Johnson
XD100 .
LOW OIL Warning Test
IMPORTANT:
For new outboards, test low oil
warning before filling oil tank.
Turn key switch to ON. The engine monitor warn-
ing display should show “LOW OIL.”
Add enough oil to raise level to at least one-quar-
ter capacity.
The “LOW OIL” warning should not display.
IMPORTANT:
Prime the oil system on Evinrude
E-TEC 15 – 90 HP models to turn OFF the “LOW
OIL” warning. Refer to 15 – 90 HP Models on
p. 82.
Failure to follow these recommen-
dations could void the outboard warranty if a
lubrication-related failure occurs.
Oil Injection Rate
The Engine Management Module ( EMM ) controls
the oil injection rate based on engine RPM. This
rate can be adjusted for the type of oil being used,
and also for powerhead break-in. Use
Evinrude
Diagnostics software to access these features.
The Set Oil Type option controls the injection rate
for the oil being used and typical operating condi-
tions.
The TC-W3 oil type setting is the standard setting
for all outboards. Set TC-W3 for:
•
Operation with all TC-W3 outboard oils includ-
ing
XD30, XD50, or XD100 .
•
Applications requiring maximum lubrication.
•
Extreme applications (commercial or harsh con-
ditions, racing or other high performance opera-
tion).
•
Use this setting with XD100 outboard oil in
extreme applications
The XD100 setting provides an option to run the
outboard at a reduced oil injection rate. This set-
ting REQUIRES the use of
Evinrude XD100 out-
board lubricant and is not recommended for all
applications.
IMPORTANT:
The XD100 setting is not avail-
able on all models.
Use the XD100 setting for:
•
Conventional use (runabouts, cruisers)
•
Moderate applications
Running an Evinrude E-TEC out-
board on other grades of oil while set to the
XD100 oil ratio will result in increased engine
wear and shortened outboard life.
NOTICE
1. Oil control setting 008580
1
NOTICE