BRP Evinrude, Руководство по установке

Страница: 11 / 100

9
BOAT RIGGING
REMOTE CONTROLS
1
Control Installation
Plan the installation of remote controls carefully,
following all instructions provided with the control.
Select an appropriate location based on the boat
configuration.
IMPORTANT:
The mounting location must be a
flat surface and must be strong enough to provide
rigid support. Strengthen mounting surface as
necessary.
Place remote control at proposed location and
check clearance around remote control lever at
full throttle in FORWARD and then at full throttle in
REVERSE. There must be at least 2.5 in. (64 mm)
of clearance between the handle and any part of
the boat throughout the control lever travel.
Use an appropriate drill template to cut mounting
holes. Templates are included with the control
instructions.
Install control with hardware provided.
IMPORTANT:
Make sure remote control assem-
bly is secure and does not move during operation.
1. Side console
2. Center console
005471
1 2
Typical control clearances 007920
1. Template 007922
85.5°
FWD
15.0°
15.0°
40.5°
NEUTRAL
REV
2.5 in (64 mm)
1