BRP Evinrude, Руководство по установке

Страница: 47 / 100

45
OUTBOARD INSTALLATION
LIFTING THE OUTBOARD
2
15–30 HP M
ODELS
Install Lifting Tool, P/N 354717, on both sides of
the tilt tube.
Use an appropriate chain, at least 36 inches (91
cm) long with two snap hooks, each capable of lift-
ing 500 lbs. (227 kg).
Attach hooks to lifting device and attach chain to
hoist.
Lift the engine out of the carton.
Remove upper motor cover.
Place clean pad or cardboard on the floor.
Lower outboard onto the pad. Use hoist to care-
fully roll the outboard onto its port side.
Remove chain from lifting tool.
Remove lifting tool from outboard.
1. Lifting tool, P/N 354717 007122
A
WARNING
To avoid personal injury or outboard dam-
age, be sure the lifting tool is fully threaded
on both sides of the tilt tube.
A
WARNING
Use this tool for horizontal lifting of 30 HP
and smaller
Evinrude E-TEC models ONLY.
DO NOT use this tool to lift outboards
larger than 30 HP
Evinrude E-TEC models.
To avoid personal injury and boat or out-
board damage, DO NOT use this tool to
install or remove outboard from transom
as outboard can unexpectedly tip.
1
1. Lifting tool, P/N 354717 007123
A
CAUTION
To avoid damage to the outboard, DO NOT
allow the outboard to fall unrestrained.
007211
1