BRP E 250 L HO AG B, Руководство по обслуживанию

Страница: 377 / 460

377
Gearcase
Gearcase Disassembly (Standard Rotation)
14
inserted between the puller and the gearcase until
the driveshaft pops loose from the pinion.
Oil Pump Service
The SLX-Type gearcase uses an Archimedes
Screw Pump, to circulate oil through the gear-
case.
Removal
Insert the blade of a small screw driver between
the notch in the retaining ring and the gearcase
housing. Turn the screw driver to move the end of
the retaining ring from its retaining groove. Use a
curved pick to work the snap ring up from the
retaining groove. Remove the snap ring from the
drive shaft bore.
If the pinion bearing is being removed, the oil
pump can be removed with the pinion bearing,
using the pinion bearing removal procedure. See
Pinion Bearing Removal on p. 380.
If the pinion bearing will not be removed, use a
Slide Hammer, P/N 432128, or P/N 391008, with
Puller Jaws, P/N 432129, to remove the oil pump.
Locate the hole in the oil pump. Align the puller
jaws with the oil hole.
Tighten the rod of the slide hammer to expand the
puller jaws into the recessed area at the bottom of
the pump. This will prevent the Archimedes screw
of the pump from being damaged.
1. Drive shaft
2. Puller
3. Backing plate
009537
1. Screw driver
2. Snap ring notch
3. Pick
009500
3
2
1
1
3
2
Oil Pump (Installed) 009575
1. Oil hole
Oil Pump (Removed) 009571
1. Oil hole
2. Puller jaws
1
1
2