BRP E 250 L HO AG B, Руководство по обслуживанию

Страница: 34 / 460

34
Routine Service
Rigging Information
Connections
Also see Rigging Center Connections on the
next page.
1. Install the positive ( + ) battery cable to the posi-
tive stud on the starboard side of the top frame.
Tighten nut to a torque of 120 to 144 in.lb.
(13.5 to 16.5 N·m).
2. Install the negative ( – ) battery cable to the neg-
ative stud on the port side of the top frame.
Tighten nut to a torque of 60 to 84 in.lb. (7 to
9.5 N·m).
3. Connect the fuel supply hose from fuel tank to
hose fitting on the outboard. Secure hose with
Oetiker clamp.
4. If installing optional remote oil tank, connect
the oil supply hose from the oil tank to the fit-
ting on the outboard. Secure hose with
Oetiker
clamp.
5. Connect the remote control network buss cable
to the outboard’s buss cable. Refer to Network
Connections on p. 34.
6. Connect the NMEA 2000 buss cable from a tee
in the boat to the outboard’s NMEA 2000 buss
cable.
7. If installing optional remote oil tank, remove the
protective cover from the harness on the out-
board. Connect the electrical connector from
the oil tank to the connector on the outboard.
8. If installing optional auxiliary battery charging
kit, remove plug from outboard harness and
discard plug. Connect the auxiliary battery
charge cable to the connector on the outboard.
Network Connections
IMPORTANT:
Do not force connectors or locking
rings. Properly aligned connectors assemble easi-
ly.
Do NOT use Dielectric Grease on buss cable
connectors.
To assemble the connectors:
•
Use the tabs to carefully align buss cable con-
nectors.
•
Look at the tabs to ensure connector alignment
prior to making the connection. Do not rotate
connectors until they align. This could result in a
mismatched connection. It is possible for each
pin to enter a socket even if the tabs are mis-
aligned.
•
Carefully align pins and sockets of connectors.
Do NOT force connectors together.
•
Pull back the coupler of the female buss con-
nector as the connectors are joined. Do NOT
force connectors together.
•
Release the coupler to lock the connectors
together.
•
Gently try to pull the connectors apart to ensure
they are locked together.
1. Tabs 009138
1. Female buss connector
2. Coupler
009139
1
1
1
2