SETUP
vbl2006-007-004
TYPICAL
NOTE:
After each maintenance service, Last Ser-
vice should be reset to keep a good track of vehi-
cle service history.
Speedometer Units
NOTE:
The speedometer is factory preset in miles
but it is possible to change it to kilometer reading.
Any unit modification is applied to the speedome-
ter, odometer and trip meter.
1. Select the SETTING tab in B.U.D.S.
2. Select CLUSTER page.
3. Select
Metric
or
Imperial
from the
Cluster
Units
section.
NOTE:
No data will be lost when changing this set-
ting.
Cluster Language
Base Models Only
The default language displayed in the multifunc-
tion gauge is English. The language can only be
changed using B.U.D.S.
1. Select the SETTING tab in B.U.D.S.
2. Select CLUSTER page.
3. In the language field, press on the drop down
arrow next to the language and choose the re-
quired language.
rmr2008-066-001_b
TYPICAL
1. Setting tab
2. Cluster Language field selection arrow
Ending a B.U.D.S. Session
NOTICE
After a problem has been solved, en-
sure to clear the fault(s). This will properly re-
set the appropriate counter(s).
1. Click on FAULT tab and check if there are active
faults. If so, service vehicle then clear the faults
in B.U.D.S
2. Click on WRITE DATA button to transfer new
settings and information to the modules.
vmr2006-012-100_ben
WRITE DATA BUTTON
3. Click on EXIT button (right most) to end session.
4. Reinstall DLC connector in its holder.
5. Reinstall RH service cover on vehicle.
34 / 39
2014-2
PREDELIVERY
