PARTS TO BE INSTALLED
7. Ensure the following cables and connectors are
accessible prior to installing front cargo module,
cut locking ties if required.
rbl2013-003-015_b
TYPICAL - REFER TO THE FOLLOWING TABLE FOR ITEMS
DESCRIPTION
ITEMS
DESCRIPTION
1
AAPTS sensor connector (hidden
on the illustration)
2
Horn connector (hidden on
the illustration)
3
Low beam headlight (CE)
4
DLC connector (B.U.D.S.)
5
Storage cover switch connector
(option package)
6
Storage cover cable
7
12 V power outlet (option package)
8. Turn up and store cable and all the wiring and
connectors in the front of the vehicle to prevent
them from being pinched between the front
cargo module and front frame.
9. Before installing front cargo module, remove
the fuse box service covers as follows:
9.1 Push down on the fuse box service covers
to open and pull the covers off.
rmo2013-003-011_a
1. Left fuse box service cover
2. Right fuse box service cover
NOTE:
Removal of fuse box service covers is
required only to aid in the alignment of the
front cargo module when installing it onto the
front frame of the vehicle.
9.2 Turn up and store all the wiring and con-
nectors on front cargo module to prevent
them from being pinched between the
cargo module and front frame.
10. Assisted by another person, position front
cargo module onto upper supports in the
front frame of the vehicle.
NOTE:
Ensure that no cable or wiring was pinched
between cargo module and front frame prior to
installing any fastener.
rbl2014-004-045_a
TYPICAL
1. Front cargo module
2. LH upper support, RH similar
11. Secure the front cargo module using following
hardware.
– At the TOP, use four M6 x 20 hexagonal
flanged forming screws.
– At the bottom, use two M6 x 12 hexagonal
flange screws.
12 / 39
2014-2
PREDELIVERY
