SETUP
rmr2008-031-003
TYPICAL - SWING ARM ALIGNS WITH A SPOKE
7. Position the sensor behind the LH passenger
footrest and hold the sonic tension meter sen-
sor approximately 1 cm (1/2 in) from belt or
closer without touching the belt.
rbs2010-006-002
SPYDER GS/RS
8. Tap the belt to make the belt vibrate and note
the measurement.
9. Repeat step 8.
NOTE:
The second value should be within ±25N. If
not, repeat measurements until tolerance is met.
rmr2008-031-004_a
TYPICAL – SPYDER RS SHOWN
1. Tap the belt
2. Sonic tension meter sensor
10. Repeat steps 6 to 9 for the 2 remaining wheel
spokes.
The average of the 3 obtained values (at the 3
spokes) must be within the following range:
DRIVE BELT TENSION
(PARTS AT ROOM TEMPERATURE AND
REAR WHEEL LIFTED)
1050N ± 150N
If the tension of drive belt is out of specification,
adjust drive belt as per
DRIVE BELT TENSION AD-
JUSTMENT
. Refer to
DRIVE SYSTEM
subsection
in the proper
CAN-AM ROADSTER SHOP MAN-
UAL
.
Clutch Lever
NOTE:
The distance between the clutch lever and
handgrip can be adjusted from position 1 (greatest
distance) to position 4 (smallest distance).
1. Adjust the clutch lever as per the owner’s pref-
erence.
1.1 Push the clutch lever forward to release
the adjuster dial. Hold in position.
1.2 Turn the adjuster dial to the desired posi-
tion aligning the dial number with the dot
on the lever.
1.3 Release the clutch lever.
rmo2010-001-033_a
CLUTCH LEVER ADJUSTMENT
1. Clutch lever
2. Adjuster dial
3. Dot
Lights
Headlight Aiming Adjustment
North American Models
Position the vehicle 10 m (33 ft) in front of a test
surface as shown.
Have a person of at least 91 kg (200 lb) taking
place on the driver's seat.
30 / 39
2014-2
PREDELIVERY
