Brother HL-1070, Руководство по обслуживанию

Страница: 82 / 244

IV-18
I-20 Horizontal lines
Possible cause Step Check Result Remedy
HV.GND
contacts
(Fig.4-5,
4-6)
SR electrode 1 Are the SR electrodes between
the printer body and the drum
unit dirty? Yes Clean both
electrodes.
➈
SR connection
failure 2 Are the SR electrodes between
the printer body and the drum
unit connected correctly? No Check the SR
connection.
Feed roller 3 Are the feed roller shaft and
the ground contact connected
correctly? No Check the
connection between
the shaft and the
ground contact.
➉
I-21 Light rain
Possible cause Step Check Result Remedy
Drum unit failure 1 Is the problem solved after
replacing the drum unit which
contains no more starter
sheet**? Yes Replace the drum unit.
SR PCB failure 2 Is the problem solved after
replacing the SR PCB? Yes Replace the SR PCB.
High-voltage
power supply
PCB failure 3 Is the problem solved after
replacing the High-voltage
power supply PCB? Yes Replace the High-voltage
power supply PCB.
**Note: Make sure to use the used drum unit which has already ejected the starter
sheet. It is not possible to find the drum unit failure if you use a new drum unit
with the starter sheet.
Note: Make the printer in the light rain test mode as follows before
checking;
1. Turn on the power switch and open the top cover.
2. Hold down the panel switch until all the lamps are on, and
then release the switch.
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com