Brother BAS-6150, Инструкция по эксплуатации

Страница: 80 / 107

Chapter 7 Environment setting
BAS-6150
78
NO. Item Display Contents (configurable values)
Center knife offset - end of
sewing correction
Corner knife home position
detection
Corner knife offset - start of
sewing correction
Corner knife offset - end of
sewing correction
Start switch allocation
Steps start
Auto start
Standby time for the start of
sewing
Foot switch operation
Settings for the foot switch
timer
Distance to start releasing
the upper thread retention
Upper thread retention
releasing time
Upper thread trimming
knife descent timing
0.0
0.0
0.0
0.0
10
0.020
30
13
14
15
16
17
18
19
20
21
22
23
24
25
Initial
value
-9.9 to 9.9mm (in the unit of 0.1 mm)
-9.9 to 9.9mm (in the unit of 0.1 mm)
-9.9 to 9.9mm (in the unit of 0.1 mm)
Operation stops at the needle down position after feeding
and sewing starts again when the start switch is set to ON.(
for confirmation of the cloth guide)
Set auto start to in certain time after the last
presser goes down.
0.0 to 99 second(s)
Setting is performed as for how many seconds later sewing
is to start when the auto start is ON and when the start
switch is pressed.
Setting is performed for operation interval by setting the
display to ON and with operation of the foot switch.
0 to 30 mm (in the unit of 1 mm)
Distance from the start of sewing to the start of releasing the
upper thread.
When the distance is set to 0, the upper thread is released
before the machine rotates. This function can works when
the upper thread is stitched in at the start of sewing. The end
of releasing is operated by the timer. No.24
0.005 to 0.1 second
Releasing time of the upper thread retention.
0 to 50 mm (in the unit of 1 mm)
Distance from the end of sewing to the start of the upper
thread’s descent.
(This setting is performed to adjust the amount of the
remained upper thread.)
To be detected only for power on and emergency stop
To be detected for every sewing
Right foot switch
Center foot switch
Setting is performed as for which foot switch should be functioned as
a start switch.
Step
Timer (programmable)