Brooks EIB3018, Инструкция по эксплуатации

Страница: 45 / 60

45
Interconnected Alarms
do not all sound • Hold test button for 10 seconds after the first alarm has sounded to
ensure signal is transmitted to all units.
• If this is not the case and you have a hardwired interconnection, we
recommend you consult a licensed electrician.
• If the Alarm is fitted with an RF module for wireless
interconnection, check that all Alarms in the RadioLINK system
are powered and are house-coded correctly. (see the EIB3000MRF
Ra module manual)
Pressing the Test/Hush
button does not silence
the Alarm Always make sure that you are pressing the Test/Hush button on the
Alarm that sounds with the red LED flashing.
Your Alarm chirps/beeps/
flashes
In standby mode, the Alarm does not sound, beep, chirp or flash. The
only light on is the green power LED.
The Alarm automatically monitors the battery, sensor and electronics
periodically to ensure that all are satisfactory. If a fault has been
found, the alarm alerts the occupier to this via short chirps from its
sounder and yellow LED fault indicator flashes every 48 seconds. The
alarm will also indicate any faults when the test button is pressed.
See indicator summary table on the next pages