Brooks EIB3018, Инструкция по эксплуатации

Страница: 12 / 60

12
2.1 Important Safety Instructions
Mains operated Alarms
should be installed and interconnected by a licensed electrician
in accordance with the relevant Regulations for Electrical Installations. Failure to install this
Alarm correctly may expose the user to shock or fire hazards and damage the product.
The Alarm is designed to be permanently mounted, using its own built-in terminal block to
connect it to the mains. The mounting plate can be screwed directly to the ceiling. Alternatively,
it can be screwed to a standard junction box. It requires a typical current of 3mA. The Alarm
must not be exposed to dripping or splashing. There are important markings on the underside
of the Alarm.
It is a requirement that CO Alarms must be installed by a competent person.
Alternative Energy Sources - (Wind, Solar, UPS etc.)
This product is designed to be connected to a Pure or True Sine Wave 230V AC supply.
If connecting to a power source that utilises an inverter, e.g. PV solar panel, the Total Harmonic
Distortion (THD) must be less than 5%. If in doubt please check with the manufacturer of the
inverter. This also applies to battery powered UPS (Uninterruptible Power Supply) inverters.
Light Dimmer Circuits
– The Alarms must not be powered from a light dimmer circuit.
Do not install Alarms in new or renovated buildings until all work is completed.
The Alarm must
not
be connected when the house wiring insulation is being checked with
high voltages. i.e. Do
not
use a high voltage insulation tester on the Alarm.