Brooks EIB3018, Инструкция по эксплуатации

Страница: 13 / 60

13
The Alarm must be continuously powered 24 hours a day so it is important that it is not on a
circuit that can be turned off by a switch.
The power supply for the Alarms should be derived from the public electricity supply to the
dwelling. The mains supply to the Alarms should take the form of either:
(a) an independent circuit at the dwelling’s main distribution board, in which case no other
electrical equipment should be connected to this circuit (other than a dedicated monitoring
device installed to indicate failure of the mains supply to the Alarms); or
(b) a separately electrically protected, regularly used local lighting circuit.
Alarms should be connected on a single final circuit, unless the means of interconnection is
by radio signals (e.g. RadioLINK).
2.2 Where to locate the Alarm
The EIB3028 Heat and CO Alarm can be installed for dual protection against Fire and Carbon
Monoxide anywhere a Heat Alarm is recommended/specified. It is ideal for kitchens, garages, boiler
houses and other areas where there are normally high levels of fumes, smoke or dust i.e. places where
Smoke Alarms cannot be installed without the risk of excessive nuisance alarms and where often a
fuel burning appliance is present.
A Carbon Monoxide Alarm like the EIB3018 should be installed in:
- Every room containing a fuel burning appliance
- Remote rooms where occupants spend a considerable amount of time
- Every bedroom