Brocade Communications Systems ICX 7250 series, Руководство по настройке

Страница: 349 / 483

Syntax: [no] snmp-server enable traps bgp
Use the no form of the command to disable BGP4 traps.
Configuring BGP4
Once you activate BGP4, you can configure the BGP4 options. There are two configuration levels: global and address family.
At the global level , all BGP4 configurations apply to IPv4 and IPv6. Enter this layer using the device BGP4 command
Under the global level, you specify an address family . Address families separate IPv4 and IPv6 BGP4 configurations. Go to this level by
entering the
address-family command at the device BGP4 level. The command requires you to specify the IPv4 or IPv6 network
protocol.
The address-family command also requires you to select a sub-address family, which is the type of routes for the configuration. Specify
unicast routes.
TABLE 49 IPv4 BGP4 commands for different configuration levels
Command Global (iPv4 and IPv6) IPv4 address family unicast
address-family x x
aggregate-address x
always-compare-med x
always-propagate x
as-path-ignore x
bgp-redistribute-internal x
client-to-client-reflection x x
cluster-id x
compare-med-empty-aspath x
compare-routerid x
confederation x
dampening x
default-information-originate x
default-local-preference x
default-metric x
distance x
enforce-first-as x
exit-address-family x x
fast-external-fallover x
graceful-restart x
install-igp-cost x
local-as x
log-dampening-debug x
maxas-limit x
maximum-paths x
med-missing-as-worst x
multipath x
Configuring BGP4
Brocade FastIron Layer 3 Routing Configuration Guide
53-1003903-04 349