Brocade Communications Systems ICX 7250 series, Руководство по настройке

Страница: 140 / 483

Syntax: snmp-client ipv6 ipv6-address
The ipv6-address you specify must be in hexadecimal format using 16-bit values between colons as documented in RFC 2373.
Specifying an IPv6 SNMP trap receiver
You can specify an IPv6 host as a trap receiver to ensure that all SNMP traps sent by the device will go to the same SNMP trap receiver
or set of receivers, typically one or more host devices on the network. To do so, enter a command such as the following.
device(config)#snmp-server host ipv6 2001:DB8:89::13
Syntax: snmp-server host ipv6 ipv6-address
The ipv6-address you specify must be in hexadecimal format using 16-bit values between colons as documented in RFC 2373.
Configuring SNMP V3 over IPv6
Brocade devices support IPv6 for SNMP version 3. For more information about how to configure SNMP, refer to Brocade FastIron
Management Configuration Guide .
Secure Shell, SCP, and IPv6
Secure Shell (SSH) is a mechanism that allows secure remote access to management functions on the Brocade device. SSH provides a
function similar to Telnet. You can log in to and configure the Brocade device using a publicly or commercially available SSH client
program, just as you can with Telnet. However, unlike Telnet, which provides no security, SSH provides a secure, encrypted connection to
the Brocade device.
To open an SSH session between an IPv6 host running an SSH client program and the Brocade device, open the SSH client program
and specify the IPv6 address of the device. For more information about configuring SSH on the Brocade device, refer to "SSH2 and
SCP" chapter in the
Brocade FastIron Security Configuration Guide .
IPv6 Telnet
Telnet sessions can be established between a Brocade device to a remote IPv6 host, and from a remote IPv6 host to the Brocade device
using IPv6 addresses.
The telnet command establishes a Telnet connection from a Brocade device to a remote IPv6 host using the console. Up to five read-
access Telnet sessions are supported on the router at one time. Write-access through Telnet is limited to one session, and only one
outgoing Telnet session is supported on the router at one time. To see the number of open Telnet sessions at any time, enter the
show
telnet command.
To establish a Telnet connection to a remote host with the IPv6 address of 2001:DB8:3de2:c37::6, enter the following command.
device#telnet 2001:DB8:3de2:c37::6
Syntax: telnet ipv6-address [ port-number | outgoing-interface ethernet port | ve number ]
The ipv6-address parameter specifies the address of a remote host. You must specify this address in hexadecimal using 16-bit values
between colons as documented in RFC 2373.
The port-number parameter specifies the port number on which the Brocade device establishes the Telnet connection. You can specify a
value between 1 - 65535. If you do not specify a port number, the Brocade device establishes the Telnet connection on port 23.
IPv6 management (IPv6 host support)
Brocade FastIron Layer 3 Routing Configuration Guide
140 53-1003903-04