G730-Install-IG100 Installation Guide
Brocade
®
G730 Switch Hardware Installation Guide
Removing a Fan Assembly
Perform the following steps to remove a faulty fan assembly:
1. To leave the device in service while removing a fan assembly, verify that the other power supplies and fan assemblies
(the ones not being replaced) have been powered on for at least 4 seconds and have a steady green LED.
Figure 44: Removing a Fan Assembly
1. Fan Assembly Unit
2. Fan Assembly Handle
2. Using a Phillips screwdriver, unscrew the captive screw.
3. Remove the fan assembly from the chassis by pulling the handle out and away from the chassis. The fans in the other
power supply automatically switch to high speed to maintain adequate cooling.
Inserting a New Fan Assembly
Complete the following steps to insert a new fan assembly into the chassis.
The new fan assembly must have the same part number and airflow label (or lack thereof) as the fan assemblies already
installed.
1. To leave the device in service while installing a fan assembly, verify that the other fan assemblies (the ones already
installed) have been powered on for at least 4 seconds and have a steady green LED.
2. Using a Phillips screwdriver, unscrew the captive screw of the filler panel that is located in the empty fan assembly
slot.
3. Orient the new fan assembly with the captive screw on the right, as shown in the following figure.
Do not force the installation. If the fan assembly does not slide in easily, ensure that it is correctly oriented before
continuing.
G730-Install-IG100
74
Содержание Brocade G730
Страница 94: ......