Broadcast DPS ES-2200, Руководство оператора

Страница: 15 / 70

14
Figure 2-2: ES-2200T Controls
Unit Select
The UNIT select button is used to address the selected installed card. Whenever UNIT 1 is selected, all of the front
panel controls and indicators display the current parameters of the card installed in the UNIT 1 slot. When UNIT 2 is
selected the front panel controls and indicators display the current parameters of the card that is installed in the UNIT 2
slot. This button is also used to select remote/local operation.
UNIT 1
When this button is selected, the ES-2200T will recall and display the current status of the card that is connected in the
UNIT 1 slot. A flashing UNIT 1 LED indicates that the installed card is not responding to the ES-2200T commands. If
this happens then make sure that the Baud rate of both the front panel and the installed card are the same and that the
serial interface cable is connected. Note that this LED will not flash if the installed unit is a V-Scope or a Personal
Routing Switcher card because the ES-2200T does not poll these cards.
UNIT 2
When this button is selected, the ES-2200T will recall and display the current status of the card that is connected in the
UNIT 2 slot. A flashing UNIT 2 LED indicates that the installed card is not responding to the ES-2200T commands. If
this happens then make sure that the Baud rate of both the front panel and the installed card are the same and that the
serial interface cable is connected. Note that this LED will not flash if the installed unit is a V-Scope or a Personal
Routing Switcher card.
REMOTE
The remote function causes the ES-2200T to go into remote mode. The installed Personal series cards can then accept
commands from a remote source such as a computer or a remote control module. The commands are accepted via the
rear panel's DB-9 female connector, and are processed by the front panel and echoed to the selected UNIT. Holding in
the SELECT button for approximately one second activates this function. When this function is active, the front panel
UNIT 1 and UNIT 2 LEDs both light up. To select local mode simply press the UNIT 1/ UNIT 2 button once.
SELECT TIMING INPUT FREEZE BALANCE PROC AMP
UNIT UNIT H-POS C F NTSC SVHS FRM/FLD TAKE RED BLUE VIDEO BLACK CHROMA HUE
1 2 FLAT LOW 1H 2H PK/VAR FREEZE NRM SUPER WAVFRM VECTOR OVERLAY SPLIT
REMOTE CONFIGURE STROBE FILM MD STORE RECALL PREVIOUS UNITY
VRT BLKG MONO GEN MD BURST BLK OUT GEN TERM CMB FLTR HOT SW
5 MAX
4 +
3 UNITY
2 -
1 MIN
Shaft Encoder