28
29
HOW TO USE
HOW TO USE
C.
Ensure slack is removed from the lap straps
by pulling the shoulder harness straps through
the buckle tongues, then pull the Harness
Adjustment Strap to take up the slack in the
harness, adjusting to a firm but
comfortable fit. Make sure that
the baby’s arms and legs are
free and the crotch strap is
between the legs. Check that
the slack in straps is minimal.
Do not use the restraint if
straps do not tighten and
contact your local authorised
service agent for repair.
Pull Harness Straps
through the buckle in
direction of arrows
Pull Harness Adjustment
Strap to remove slack.
Hook the Adjuster Strap on to the loop
to prevent tripping over the strap.
Ensure the end of the harness Adjustment Strap is connected to the cover
to avoid tripping on the end. Ensure the Harness adjustment strap hook is
attached when carrying the carrier (see above).
CAUTION: A LOOSE HARNESS IS DANGEROUS
IMPORTANT:
Do not place the Infant Carrier on a table or a work-top, where it could fall off or be
knocked on to the floor.
PLACING BABY & INFANT CARRIER IN BASE
Click
A.
Position the Infant Carrier over the top of the
base. Make sure the Harness Adjustment Strap is
not caught between Infant Carrier and Base then
lower the Infant Carrier into position.
IMPORTANT:
Lift again to check engagement.
C.
The handle may be rotated into other positions if
needed although this may be difficult with the seat
in front.
B.
Push down on the Infant Carrier until an
audible click is heard. Pull on the Infant Carrier
to ensure it is correctly locked into position.